Canon DADF-P1, Service Manual

Page: 54 / 90

Chapter 3
3-14
3.4.7.3 Removing the Rear Cover
0010-6622
1) Open the feeder cover.
2) Move to the back of the machine, remove the two screws [1], and then
detach the rear cover [2].
F-3-87
Remove the rear cover with the two claws [3] released.
3.4.7.4 Removing the ADF Driver PCB
0011-3233
1) Disconnect all connectors from the ADF driver PCB. (10 connectors)
2) Remove the two screws [1], and then remove the ADF driver PCB [2].
F-3-88
3.4.7.5 Removing the Pickup Motor
0010-6636
1) Disconnect the connector [1], and then remove the tension spring [2].
2) Remove the two screws [3], and then remove the pickup motor [4]
together with the adjusting plate.
F-3-89
3.4.7.6 Removing the Feed Motor
0010-6644
1) Disconnect the connector [1], and then remove the tension spring [2].
2) Remove the two screws [3], and then remove the feed motor [4] together
with the adjusting plate.
F-3-90
3.4.7.7 Removing the Timing Belt
0010-6651
1) Remove the screw [1], and then disconnect the ground cable [2].
F-3-91
2) Disconnect the two sensor connectors [1].
3) Remove the harness from the harness guide [2].
4) Remove the screw [3], and remove the harness guide [2].
5) Remove the two screws [4], and then remove the metal plate [5].
6) Remove the four screws [6], and then remove the left hinge [7].
[1]
[3]
[2]
[2]
[1]
[3]
[4]
[1] [3]
[2]
[1] [4]
[2]
[3]
[2] [1]