Canon DADF-P1, Service Manual

Page: 46 / 90

Chapter 3
3-6
F-3-31
3.4.1.4 Precaution about Pickup Roller Unit Installation
0010-3979
- Install the pickup roller unit with the stopper arm [1] at the front as shown
below.
- Install the pickup roller unit with the stopper [2] at the rear as shown below.
F-3-32
3.4.2 Pickup Roller/Separation Roller
3.4.2.1 Removing the Front Cover
0010-6356
1) Open the feeder cover [1], and then remove the screw [2].
F-3-33
2) Remove the two screws [3], and then detach the front cover [4].
F-3-34
3.4.2.2 Removing the Feeder Cover
0010-6357
1) Remove the screw [1] and positioning pin [2], and then detach the feeder
cover [3].
F-3-35
3.4.2.3 Removing the Pickup Roller Unit
0010-6358
1) Release the two hooks [1], and then detach the inner cover [2] of the feeder
cover.
F-3-36
2) Remove the two resin rings [1] and the two bearings [2], and then remove
the pickup roller unit [3].
F-3-37
3.4.2.4 Removing the Pickup Roller and Separation
Roller
0010-3988
1) Remove the screw [1], and then remove the drive gear [2].
[1] [2] [3] [2] [1]
[1]
[2]
[1]
[2]
[3]
[4]
[3]
[2]
[1]
[1] [2] [1]
[1] [2] [3] [2] [1]