Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
View of completed model
Assembly Instructions : Six A4 sheets (No. 1 to No. 6)
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.
* This model was designed for Papercraft and may differ from the original in some respects.
Before starting assembly:
Writing the number of each section on its back side before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out the sections.)
The parts used will vary somewhat, depending on whether the completed vessel will be modeled to depict
a ship facing wind from the left (with the bow pointed to the right) or from the right (with the bow pointed to
the left). First decide where you want to display the completed vessel, then decide whether the bow should
point to the left or right.
Bow pointed to the right (A - standard parts)
Bow pointed to the left (B - optional parts)
Indicates sections that should be glued first,
then cut out.
Indicates sections that should be folded once,
then unfolded.
After folding the part once and gluing the two
folds together, cut out from the yellow area.
Glue parts 2 and 3 together in
the same way.
Indicates where sections should
be glued together.
Indicates where to insert sections.
Do not glue the sections together.
©
Canon Inc.
©
M. Nishiguchi/SENAUN
Ships of the world : Esmeralda : Assembly Instructions
http://www.canon.com/c-park/
