83
Saving/Restoring all the camera settings.
Backup/Restore
Settings related to backup and restore.
[Back Up
S
ettings]
All settings except date and time will be backed up. The administrator account and certificates used in SSL/TLS, including
private key will be backed up.
[Restore
S
ettings]
Restores all settings, except date and time, from the backup file created in [Back Up Settings].
The administrator account, IP address and certificates used by SSL/TLS, including private key will be restored.
After restoring, the camera will be rebooted.
[Encryption Password]
It is possible to set a password for backup and restore. This password is for encrypting the backup data itself. Use at least
two types of alphanumeric characters, numbers, or symbols.
When restoring from encrypted backup data, enter the password set when backing up.
Note
The settings are not restored if the password set when backing up and the password set when restoring do not match.
[System] > [Maintenance] > [Backup/Restore]
Important
Do not turn off the power to the camera while performing [Back Up Settings] or [Restore Settings]. Turning off the camera may prevent
the camera from operating correctly.
Important
• Be aware that if restored from a backup file of another camera, problems such as duplication of addresses on the network or
overwriting of a different Administrator Password may occur, preventing the connection to the camera.
• When restoring the settings, do not use a backup file created with a newer version of firmware than that of the camera to restore.
