47
Settings for the audio input from the microphone connected to the camera and for the bit rate for IP audio streaming.
General Audio
Settings for the volume of the audio input and the type of microphone.
[Audio Input]
Select whether to use audio from the microphone.
When [Disable] is selected, Audio cannot be outputted from HDMI/SDI output.
Note
To set [Audio Input] to [Disable], all of the following settings must be changed to [Disable].
– [System] > [Server] > [RTP Server] > Each stream (Main, Sub1, Sub2) > [Audio Transmission]
– [System] > [Communication] > [External Connection (IP)] > [NDI|HX] > [Audio Transmission]
– [System] > [Communication] > [External Connection (IP)] > [RTMP] > [Audio Stream]
[Audio Input Mode]
Select the type of microphone to connect to the camera: input terminals (INPUT/MIC), input method (LINE/MIC), and with or
without power to the microphone.
Note
To use a microphone that requires phantom powering, turn it on while connected, and then set it to [INPUT Terminal/MIC+48V].
[Input Volume]
Settings for the volume to be inputted from the microphone connected to the camera.
[Current Volume Level (L)], [Current Volume Level (R)]
Displays the current volume level in the status bar.
[System] > [Video and Audio] > [Audio]
S
etting Value
Input Terminal
Input Method
Power to Microphone
MIC Terminal/LINE
MIC
LINE
-
MIC Terminal/MIC
MIC
MIC
Not Supported
MIC Terminal/MIC (MIC Power On)
MIC
MIC
Supported
INPUT Terminal/LINE
INPUT
LINE
-
INPUT Terminal/MIC
INPUT
MIC
Not Supported
INPUT Terminal/MIC+48V
INPUT
MIC
+48V
Caution
When using a microphone, set [Audio Input Mode] correctly according to the specifications of the microphone.
Failure to do so may damage the camera or microphone.
