Canon Colorado 1630, Operation Manual

Page: 115 / 388

Load a take-up roll core onto the roll winder
Introduction
When you want to wind media, you must load a take-up roll core onto the roll winder first.
For inside winding, you need the new take-up media shaft. The gear inside the new take-up
media shaft is marked with the number 2.
IMPORTANT
Make sure you use the core of an empty media roll with the same width or wider as the media
you are printing on.
Procedure
1.
Locate the winder on the media output side.
Load a take-up roll core onto the roll winder
Chapter 4 - Handle the media 115