Canon Color imageRUNNER C5180 Series, Service Manual

Page: 139 / 851

Chapter 5
5-9
5.4 Actions when HDD Error
5.4.1 E602 Details
E602-XXYY
-
When XX=00
*1
CHK-TYPE = COPIER>FUNCTION>SYSTEM>CHK-TYPE
(Specifies the partitions to be formatted by HD-CLEAR)
HD-CHECK = COPIER>FUNCTION>SYSTEM>HD-CHECK
(Performs Write Abort repairs for the entire HDD when CHK-TYPE = 0)
HD-CLEAR = COPIER>FUNCTION>SYSTEM>HD-CLEAR
(Formats the partitions specified by CHK-TYPE)
T-5-4
XX YY Description Remedy
00
01
HDD cannot be
recognized. Boot
partition (BOOTDEV)
not found during startup.
1. Turn the Main Power Switch OFF and check the HDD cable connection. After
confirmation, turn the Main Power Switch ON.
2. After turning the Main Power Switch ON, check that the HDD spins up and that
5 V/12 V power is being supplied.
3. If the above does not correct the problem, replace the HDD and reinstall the
system. If this doesn't work, replace the main board.
02
No system for main
CPU
1. Start the system in Safe Mode (1+7), perform a full format using SST, reinstall the
system (System, Lang, RUI), and turn the Main Power Switch OFF and then ON
again.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
03
WriteAbort detected for
Boot Device
1. Perform Write Abort Sector detect and repair.
<When a monochrome-related Error Code is displayed>
1-1. Since Service Mode cannot be entered, perform the following procedure.
1-2. Turn the power OFF. Turn the power ON again while holding down the 1 and
9 keys. This will automatically start the Write Abort Sector repair routine, causing
the screen to go completely black.
1-3. Progress status will appear after a short time as this routine takes about 40 to 50
minutes to execute. Execution is done when the screen goes completely white.
<When wrench mark (normal indication) is displayed>
1-1. Set CHK-TYPE = 0, execute HD-CHECK (takes 40 to 50 minutes), and turn the
Main Power Switch OFF and then ON again.
2. If the above does not correct the problem, start up in Safe Mode, perform a full
format using SST, reinstall the system (System, Lang, RUI), and turn the Main
Power Switch OFF and then ON again.
3. If the problem is still not corrected, the HDD may be assumed to be damaged, so
replace the HDD and reinstall the system.
06 No system for sub-CPU
1. Start the system in Safe Mode (1+7), perform a full format using SST, reinstall the
system (System, Lang, RUI), and turn the Main Power Switch OFF and then ON
again.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.
07 No ICCProfile
1. Start the system in Safe Mode (1+7), perform a full format using SST, reinstall the
system (System, Lang, RUI), and turn the Main Power Switch OFF and then ON
again.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.