Entering Characters from the Touch Panel Display
2-28
2
Basic Oper
ations
NOTE
•
If you make a mistake when entering characters, press [ ] or [ ] to position the cursor
➞
press [Backspace] to delete the characters
➞
enter the correct characters.
•
To delete all of the characters you have entered, press
.
•
The available entry modes, and the maximum number of characters that you can enter vary,
depending on the type of entries you are making.
2
When you have entered all characters, press [OK].
Values in Inches
If you want to enter values in inches in all modes which require a numeric entry, set Inch Entry
to 'On' in Common Settings (from the Additional Functions screen). (See "Inch Entry," on
p. 4-31.) This enables you to enter values in inches when you press [Inch] on a screen requiring
a numeric entry or measurement.
The following example shows you how to enter 1 1/2" for Original Size in the Zoom Program
mode.
1
Press [1]
➞
[_]
➞
[1]
➞
[/]
➞
[2] using the numeric keys on the touch
panel display.
NOTE
•
If you make a mistake when entering values, press [C] on the touch panel display
➞
enter the
correct values.
•
You can enter only 2, 4, 8, or 16 as the denominator.
•
The value entered in inches is converted to millimetres by the machine each time it is entered.
Thus, there may be a slight difference between the value calculated and the actual value
entered.
•
To enter values in millimetres, press [mm].
