Canon C3220, Copying Manual, Page: 59 / 372

Reserved Copying
1-37
1
Introduction to Cop
ying
If you specify a reserved copy job while the machine is printing, copying of the
new job automatically begins when the current job is complete. If the following
screen is displayed, press [OK]
➞
try reserving the job again after the current job
is complete.
Scanning starts.
Using the Stack Bypass
You can perform reserved copying from the stack bypass by specifying in advance
the paper to be loaded for the next job. However, this is possible only if paper is
being fed from the stack bypass for the current job.
The following example assumes that 11" x 17" plain paper is being fed from the
stack bypass for the current job, and that you are selecting LTR plain paper to be
fed from the stack bypass for a reserved job.
NOTE
•
If Stack Bypass Standard Settings in Common Settings (from the Additional Functions
screen) is set to 'On', reserved copying can be performed only for the registered paper
size and type. (See Chapter 4, "Customizing Settings," in the
Reference Guide .)
•
If you select [Envelope], [Transparency], [Tracing Paper], [Labels], [Tab Paper], or [Washi
(JPN paper)], make sure that you do not specify any Finisher modes (Collate, Group, or
Staple).