Canon 600EXII-RT, Instruction Manual

Page: 98 / 148

98
a : Fully Automatic Wireless Flash Photography
7
Check the performance.
Press the master unit’s test flash
button.
X The flash fires. If it does not fire,
check that it is placed within the
transmission range (p.90).
8
Take the picture.
Set the camera and take the picture
in the same way as with normal flash
photography.
X If the standard flash exposure was
obtained, the flash exposure
confirmation lamp lights for approx. 3
sec.
The master/slave flash coverage is set to 24 mm. You can also set the
flash coverage manually.
To fire the master unit as well, set the master flash firing to ON (p.94) in
step 5 on the preceding page.
You can press the depth-of-field preview button on the camera to fire the
modeling flash (p.47).
If the slave unit’s auto power off takes effect, press the master unit’s test
flash button to turn on the slave unit. Note that the test flash cannot be
performed while the camera’s metering timer, etc. is operating.
You can change the time until the slave unit’s auto power off takes effect
(C.Fn-10/p.115).
You can disable the blinking of the AF-assistant beam emitter when the
slave unit is recharged (C.Fn-23/p.117).