Canon 3114C008, Online Manual, Page: 187 / 480

Print settings
Select this menu from Device settings in Setup menu .
• Prevent abrasion
Use this setting only if the print surface becomes smudged.
Important
• Be sure to set this back to OFF after printing since it may result in lower printing speed or lower
print quality.
• Amount of extension
Select the amount of image that extends off the paper when performing Borderless Printing/Copying.
When performing Borderless Printing/Copying, slight cropping may occur at the edges since the printed/
copied image is enlarged to fill the whole page. You can change the width to be cropped from the
borders of the original image as needed.
Cropped area will be larger if Amount: Large is selected.
Note
• For Borderless Printing, at Paper Size Settings at the computer, select a paper size for Borderless
Printing, then print.
• If printouts contain margins even though you are printing in Borderless, specifying Amount: Large
for this setting may help solve the problem.
• Depending on your devices or how to print, the setting may be disabled.
• Auto photo fix set.
When ON is selected, you can select whether to print photos using the Exif information recorded in the
image files when Default * or On is selected in printing with a PictBridge (Wi-Fi) compliant device.
* When Default is selected for the print setting on the PictBridge (Wi-Fi) compliant device, select Auto
photo fix for Photo fix in PictBridge settings .
• Paper print position
Adjusts the print position when the left/right margins are not aligned.
Select Rear tray or Cassette for the paper source. You can adjust their printing positions in increments
of 0.004 in. (0.1 mm) between -0.08 in. (-2 mm) and +0.08 in. (+2 mm) to the right or left with respect to
its center of the paper along the horizontal axis.
Important
• When using A4/Letter sized paper, the amount of adjustment that can be made is limited. You
cannot make adjustments greater than this limit.
187