37
Returning to a Pre-marked Position
If you wish to return to a particular
scene later, mark the point with the zero
set memory and the tape will stop at
that point when you rewind/fast forward
the tape. This function is operated with
the wireless controller.
1
While recording or during
playback, press
at the point you wish to return to
later.
• The time code changes to
“0:00:00
”.
• Press
again to
cancel the memory.
2
If you marked the zero memory
while recording, set the
camcorder to
mode. If
you marked the zero memory
during playback, press
.
3
Press
to locate the zero mark.
• If the tape counter shows a
negative number, press
instead.
•
appears and the camcorder
rewinds/fast forwards the tape.
• The tape stops at or near the zero
mark,
disappears and the
correct time code will be displayed
again.
Special Playback Modes
1
To enter most special playback modes you need to operate the buttons on the
wireless controller (
15). There is no sound during the special playback modes.
1
During some special playback modes you may notice some anomalies (blocky video
artifacts, banding, etc.) in the playback picture.
Special playback mode
Initial mode
Operation on the camcorder
or on the wireless controller
Fast playback
Normal playback
: Push the joystick (
) toward
or
(
) toward
and hold it down.
: Press and hold
or
Reverse playback
Normal playback
: Press
1 frame reverse/advance
Playback pause
: Press
or
Frame-by-frame playback
Playback pause
: Press and hold
or
Slow playback
Normal or reverse
playback
: Press
Double speed playback
Normal or reverse
playback
: Press
Return to normal playback
Special playback mode
: Push the joystick (
) toward
/
.
: Press
REW
FF
SLOW
PLAY
(
ZERO SET MEMORY
ZERO SET MEMORY
STOP
CO
PY
