Making Adjustments
Checking and Adjusting the
Punch Hole Position
■ Checking the Punch Hole Position
1. Make a print with the punch mode and check
whether the skew and side registration and the
paper stop position are within the standard.
/
/
/
ڦ
Hole
feed direction
㸺
front
㸼
㸺
rear
㸼
ڦ
Hole
/
/
/
feed direction
㸺
front
㸼
㸺
rear
㸼
ڦ
Hole
/
/
/
feed direction
㸺
front
㸼
㸺
rear
㸼
<Standard>
• 2/3 Hole Puncher Unit
L1,L2
12±1.5mm
L3
2 holes
:
73±1.5mm (LGR/ LTRR)
3 holes
:
31.5±1.5mm (11"x17"/ LTR)
40.5±1.5mm (A3/ A4)
• 2/4 Hole Puncher Unit
L1,L2
12±1.5mm
L3
2 holes
:
108.5±1.5mm (A3/ A4)
99.7±1.5mm (11"x17"/ LTR)
4 holes
:
28.5±1.5mm (A3/ A4)
19.7±1.5mm (11"x17"/ LTR)
• 4 Hole Puncher Unit
L1,L2
12mm±1.5mm
L3
92.5±1.5mm (A3/ A4)
83.7±1.5mm (11"x17"/ LTR)
■ Skew Adjustment (Mechanical
adjustment)
When the punch hole position is skew (when L1 is not equal
to L2), make the adjustment according to the following
procedure.
1. Open the front cover of the finisher.
6. Installation
62
Summary of Contents for 2/3 Hole Puncher Unit-A1
