Enter 76 End
*/$%ENTR*
*ZEND*
6. Memory / Bluetooth General Setting
6-1-3 Scan Activation Time
In general, after Scan Button is pressed down, LED light will emit a stream of
light for a scan attempt. This parameter is thus used to specify activation
duration which indicates the amount of time LED light will stays on after Scan
button is held.
*BFDE0*
Configuration Range Unit
Default Setting
5 Secs ~ 4 Min 15 Secs
1 Secs
10 Secs
6-1-4
Composite Triggers Functionality
ctionality
Some supplementary functions are necessarily executed by using composite
triggers though Scan Button primarily serves to scan barcodes, and Small
Trigger to initiate data transmission. In Memory mode, all the scanned barcode
data will be deleted by pressing small trigger and Scan button in a specified
sequence described below: while holding the smaller till the orange LED light
starts flashing rapidly, press down Scan button at the same time and then
release both buttons. Scan the appropriate label to DelAll or disable
functionality of file deletion.
*BE280*
Disable
*BE281*
DelAll
(A) Scan “Enter” barcode
(B) Scan “Scan Activation Time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-1-4 Composite Triggers Functionality
6-1-3 Scan Activation Time