4. Oven cleaning and maintenance
4.1 General notes on cleaning
GLASS PARTS
If dirty, the seal can be cleaned with a slightly damp sponge.
The lifecycle of the appliance can be extended through regular cleaning.
Wait for the oven to cool before carrying out manual cleaning operations.
Never use abrasive detergents, steel wool or sharp objects for cleaning, so
as to not irreparably damage the enamelled parts. Use only water, soap or
bleach-based detergents (ammonia).
DRIP PAN
OVEN WINDOW SEAL
It is advisable to clean the glass window with absorbent kitchen towel after
every use of the oven. To remove more obstinate stains, you can use a
detergent-soaked sponge, well wrung out, and then rinse with water.
Clean accessories with a wet, soapy sponge before rinsing and drying them:
avoid using abrasive detergents.
If greasy residues remain, immerse the pan in water and detergent.
Alternatively, you can wash the pan in the dishwasher or use a commercial
oven detergent. Never put a dirty pan back into the oven.
ACCESSORIES
After using the grill, remove the pan from the oven. Pour the hot fat into a
container and wash the pan in hot water, using a sponge and washing-up
liquid.
EN 08
4.2 Aquactiva Function
The Aquactiva procedure uses steam to help remove remaining fat and food particles from the oven.
1. Pour 300 ml of water into the Aquactiva container at the bottom of the oven.
2. Set the oven function to Static (
)or Bottom (
)heater
3. Set the temperature to the Aquactiva icon
4. Allow the program to operate for 30 minutes.
5. After 30 minutes switch off the program and allow the oven to cool down.
Warning: Make sure that the appliance is cool before you touch it.
Use distilled or drinkable water.
6. When the appliance is cool, clean the inner surfaces of the oven with a cloth.
Care must be taken with all hot surfaces as there is a risk of burns.
300 ml
3- After the cleaning process install the wire racks in reverse order.
2- To clean the wire racks either put them in the dishwasher or use a wet sponge, ensuring that they are dried afterwards.
1- Remove the wire racks by pulling them in the direction of the arrows (see below)
REMOVING AND CLEANING WIRE RACKS
4.3 Maintenance
REMOVAL OF THE OVEN WINDOW
1. Open the front window.
2. Open the clamps of the hinge housing on the right and left side of the front window by pushing them downwards.
3. Replace the window by carrying out the procedure in reverse.
