Candy Brava CDPMN 4S622PX/E, Manual

Page: 109 / 164

109
EN
When the indicator light comes on, the rinse
aid is running out and needs to be topped
up.
Dishwasher start time can be set with this
button, delaying start from 00:30 to 23:30
hours. Proceed as follows to set a delayed
start:

Press the DELAY START button ( "0:00"
will appear on the display).

Press the button again to increase the
delay (on each press the delay is
increased by 30 mins., up to a
mBRAVAmum of 23:30).
 To start the countdown, press the
"START/RESET" button. The display will
show the time remaining to the end of the
programme. At the end of the countdown,
the programme will start automatically.
Proceed as follows to cancel a delayed
start:
 Hold the
"START/RESET"
button down
for at least 3 seconds. "00" will appear on
the display "RESET" and audible signals
will sound.
 The delayed start and the selected
programme will be cancelled. The "ECO"
programme or the programme previously
stored in memory will appear on the
display.

At this point, to set off the dishwasher, a
new programme and any option buttons
must be selected, as indicated in the
"PROGRAMME SETTINGS" paragraph.
The product is set in the factory with the
audio signal enabled.
The audio signal may be muted as follows:
1. Hold the "PROGRAMME SELECTION"
button down and, at the same time,
switch on the dishwasher using the
"ON/OFF" button.
2. "SETTING" appears on the display.
3. Press the "PROGRAMME SELECTION"
button until "BUZZER" appears on the
display.
4.
Then press either the button
"HALF
LOAD" or "TABS" to change the value
from Yes to No.
5.
Switch off the dishwasher by pressing
the "ON/OFF" button to confirm the
new setting.
To turn the alarm on again, follow the same
procedure.
1.
Hold the
"PROGRAMME SELECTION"
button down and, at the same time,
switch on the dishwasher using the
"ON/OFF" button.
2. “SETTING” appears on the display.
MEMO FUNCTION (Memorising
the last programme used)
The dishwasher must ALWAYS be off
before you start this procedure.
Muted END-OF-PROGRAMME signal
(Only for free-standing models)
The length of the selected cycle will
be shown on the display. At the end of
the countdown, the programme will
automatically start and the length of
the selected cycle will be shown on
the display.
If you do not want a delayed start,
press the "DELAY START" button
repeatedly until 0:00 appears on the
display (the appliance will start
immediately).
"DELAY START" button
"RINSE AND EMPTY" indicator
light