Candy 32002152, Manual

Page: 110 / 164

110
3. Press the "PROGRAMME SELECTION"
button until “MEMO FUNCTION”
appears on the display.
4. Then press either the "HALF LOAD" or
"TABS" button to change the programme.
5. Switch off the dishwasher by pressing
the " ON/OFF " button to confirm the new
setting.
To change the stored programme, follow
the same procedure.
Enabling
1. Turn on the appliance using the
ON/OFF
button.
2.
Press the
"PROGRAMME SELECTION"
and "DELAY START " buttons together
for 5 seconds.
3. "DEMO MODE ACTIVATED" will
appear on the display.
4. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
Disabling "Demo mode"
1. Turn on the appliance using the ON/OFF
button .
2. Press the "PROGRAMME SELECTION"
and "DELAY START " buttons together
for 5 seconds.
3. "DEMO MODE DISABLED" will appear
on the display.
4. Switch off the appliance.

Close the door.

Start the appliance.
 Pressing the "TABS" and "SMART
DOOR" buttons at the same time for
about 3 seconds allows you to lock all
keys. In this way, you can prevent any
unwanted or accidental changes.
 The key lock can be cancelled by simply
pressing the "TABS" and "SMART
DOOR" buttons again or by switching off
the appliance.
Should power go out when the
dishwasher is running, a special
memory feature saves the settings and,
when power returns, the appliance
resumes the cycle from where it left off.
CHILD LOCK
The dishwasher must ALWAYS be off
before you start this procedure.
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been
disabled.
The PROGRAMME SELECTION/OPTIONS/
START DELAY options are enabled,
and by pressing these buttons you
can simulate the product's functioning
without starting a wash.
The dishwasher must ALWAYS be off
before you start this procedure.
Enabling or disabling DEMO
MODE (be used exclusively in
stores)