Candela C-8 2023, Owner'S Manual

Page: 43 / 55

84 85
Maintenance Maintenance
Checking the high-voltage battery state of charge
Before winterization and spring recommissioning, check the state of charge status of the high
voltage battery. The state of charge value during winterization should be 50-60 %.
1. Turn on the 12V battery switch.
2. Turn the key.
3. Check that the SOC status in the user interface is between 50-60%.
4. If the SOC status is below this value, charge the boat.
5. Turn off the key.
6. Turn off the 12V battery switch.
Checking the 12V battery
1. Open the sunbed hatch and remove the stowage bag.
2. Locate the 12V battery and check:
• For wear or tear on the cables and battery.
• That the cables are secured to the battery.
• That the battery and cable connections are clean and free from corrosion.
Checking the function of the rudder and the struts
NOTICE! Risk of property damage. Make sure you have an obstacle free space of
2m below the hull when extracting the rudder and struts.
1. Turn on the key.
2. Select Retraction settings in the user interface and select a new retraction mode.
3. Check that the rudder and struts reach locked postion in the new retraction mode.
4. Repeat the procedure for all retraction modes.
Checking the steering
1. Turn on the key.
2. Turn the steering wheel. Check that the rudder is moving accordingly.
Adding corrosion protection on non-stainless steel metal parts
For more information, please contact Candela.
Ensuring a smooth surface of the foil system and pod
Candela recommends preparing a surface finish of the foil system annually.
The foil system requires low drag for maximum performance. Algae growth or wear and tear can
increase drag greatly, decreasing propulsion efficiency by 30-40%.
Advice for keeping the surface of the foil system smooth:
• Apply Harbor mode when docked.
• Remove any seaweed from the foils immediately after applying Harbor mode.
• Use a boat lift when docked.
• Clean the foil system regularly.
• Have the foil system serviced to reduce the effects of wear and tear.
Cleaning the deck and cabin
Use a medium-bristled brush, warm water, and an all-purpose, mild cleaner or washing-up liquid.
The deck manufacturer recommends Dek Magic. Do not use a high pressure washer.
Cleaning the foil system
1. Scrub the rudder, struts, foil, and pod with a hard brush. If necessary, use a non-abrasive
detergent.
2. Continue until the surface is smooth.