Rev 1.0
7
3
Navigation on the display
Your data display can be operated via the two buttons on the front as well as using the CANchecked
knob (CC20001).
3.1
Using the buttons on the display
The two buttons (L/R) are embedded on the left and right of the front of the plexiglass pane.
Attention:
With the MFA 2.0 Gen2 these buttons are not available, for this reason a rotary knob is
always included in this configuration.
If both buttons are pressed and held simultaneously (L+R) before switching on the data display, you
will be taken to the menu instead of the regular page view, in the menu you can define the basic
settings.
Figure 2: Page view
Figure 3: Menu
The assignment of the functions of the buttons can be freely defined in the
oDSS
. By default, the
buttons are assigned as follows:
The left button (L) changes with a short press:
•
In page view, moves the page to the left
•
In the menu the selection to the top
The right button (R) changes with a short press:
•
On the page view, moves the page to the right
•
In the menu the selection down
Briefly pressing (tapping) both buttons simultaneously (L+R):
•
Has no effect in page view
•
Confirms the current selection in the menu
The long press (three seconds) of both buttons at the same time (L+R):
•
Turns Wi-Fi on or off on the page view
•
Has no effect in the menu
