Chapter 3 Setup Menu
7.
Press the
Cancel
key to return to the Select Report menu.
Print Header
The Print Header menu item allows you to choose to enable or disable printing the
report header. The title lines (the top three lines) will always be printed. The calibration
and procedure counting information in the header may be suppressed using this menu
option.
To enable/disable the report header:
1.
Press the
Setup
key.
2.
Using the arrow keys, position the cursor “>” to item “6” in the menu, Define
Report, and then press the
Enter
key.
3.
Using the arrow keys, position the cursor “>” to select the desired report to
define or modify and then press the
Enter
key.
4.
Using the arrow keys, position the cursor “>” to item “6”, Print Header, and
then press the
Enter
key.
5.
The cursor “>” will identify the current selection.
6.
Select Print Header mode desired, “OFF/Disable” or “ON/Enable” and then
press the
Enter
key to return to the Define Report main menu.
7.
Press the
Cancel
key to return to the Select Report menu.
Define Std Source
Twenty-six User Sources can be defined and stored in the iMatic memory for system
calibration. The iMatic contains a built in isotope library of the eleven most likely
isotopes you might choose for system calibration. Isotopes, not included on this list,
may be manually entered. The system will decay correct the activity for each source for
efficiency calculations.
When received, the iMatic will have three User Sources already entered; a BkgBlank
(Background Blank), an
241
Am alpha standard (required for system gain calibration)
and a
90
Sr beta standard. These are the sources used to calibrate this iMatic.
44
iMatic Automatic Counting System User's Manual - 9239221K
