14
CAN Srl
–
CU 3002
–
ENGLISH
–
Rev 1/2018
GAS CONNECTION
ATTENTION -
Before connecting, ensure the gas system and the
installation premises comply with the provisions of standards in force in
the country of use (UNI-CIG 7129 and 7131) or the specific sector
standards.
•
Ensure the power line is free of obstructions and of adequate capacity to
ensure correct operation of the appliance.
•
Ensure that immediately downstream of the cylinder or the gas container
used to power the system that there is an adequate pressure
regulator/reducer which complies with the categories of gas usable on the
appliance.
•
Ensure that on the power supply line, downstream of the regulator, in an easily
accessible and inspectionable place, there is a shut-off tap for the gas or
valve to section the system: this valve should always be closed during
installation and maintenance operations on the appliance.
ATTENTION -
Check the type of gas used to power the appliance is
among those listed in this instructions booklet.
The appliance was designed for correct operation only with the types and working
pressures of the categories of gas below:
GAS CATEGORY AND
COUNTRY OF INTENDED USE
NAME OF GAS
WORKING
PRESSURE
I3B/P (30)
AT-BE-DE-DK-FI-GB-NL-NO-PT-
SE-SI
Butane (G30)
Propane (G30)
30
mbar
30
mbar
I3+ (28-30/37)
BE-CH-ES-FR-GB-IE-IT-PT-SI
Butane (G30)
Propane (G31)
28-30
mbar
37
mbar
ATTENTION
–
connection of the appliance to the gas piping must be
carried out using a suitable connection tube and compression fittings,
certified and the most suitable for the application. All installation and
connection operations must be performed only by qualified technical
staff.