FLUIDS
Check clutch fluid level inside the reservoir:
– The fluid must be flush to the fill level line (pro-
tuberance on the reservoir wall).
rmo2013-003-040_a
FLUID REMOVED FOR CLARITY PURPOSE
1. Minimum
2. Maximum
8. Add recommended fluid as required.
Do not
overfill.
WARNING
Avoid getting brake fluid on skin or in eyes
— it may cause severe burns. In case of con-
tact with the skin, wash thoroughly. In case
of contact with the eyes, immediately rinse
with plenty of water for at least 10 minutes
and then consult a doctor immediately.
NOTICE
Immediately wipe up spills if neces-
sary.
9. Ensure that the seal located inside the cap is
collapsed.
10. Reinstall the cap on the reservoir.
11. Tighten cap screws.
12. Wipe off reservoir if necessary.
Engine Coolant
WARNING
When opening the reservoir, the coolant can
be very hot and spray out if the engine is
hot. In order to avoid getting burned, check
coolant level when engine is cold.
Recommended Coolant
The cooling system must be filled with distilled
water and antifreeze solution (50% distilled water,
50% antifreeze).
For best performance, use
LONG LIFE ANTIFREEZE
(P/N 219 702 685)
.
Coolant Level Verification
1. Park vehicle on a firm level surface.
2. Pull out the service cover with both hands.
3. Check the coolant level on the right hand side.
Coolant must be visible slightly above the
COLD. level mark.
rmo2013-005-001_a
1. Coolant reservoir cap
4. If required, add coolant until it is visible in the
reservoir slightly above the COLD level mark.
Use a funnel to avoid spillage.
Do not overfill.
5. Stop adding coolant once coolant starts to ap-
pear in the tube.
rmo2014-001-003_a
1. Coolant level reference line (HOT)
6. Reinstall the service cover.
28 / 41
2014-3
PREDELIVERY
