Can-Am Spyder RT 2019, Operator'S Manual

Page: 152 / 187

MULTIFUNCTION GAUGE REGULATORY
INFORMATION
Technical Information
Transmitter:
– BT operating frequency range:
2402 – 2480 MHz
– BT version: 4.2 (no BTLE)
– BT output power: < 8.5 dBm
Receiver:
– FM operating range: 76 - 108 MHz
Manufacturer and Address
Manufacturer:
– Robert Bosch LLC
Address:
– 38000 Hills Tech Drive,
Farmington Hills, MI 48331,
USA
To display the regulatory information
on the vehicle digital display: From the
home screen, access the main menu
and keep the joystick pressed down
for more than 10 seconds.
USA and Canada
This device complies with FCC Part 15
and Industry Canada license exempt
RSS standard(s). Operation is subject
to the following two conditions:
(1) this device may not cause interfer-
ence, and
(2) this device must accept any inter-
ference, including interference that
may cause undesired operation of the
device.
Le présent appareil est conforme aux
CNR d'Industrie Canada applicables
aux appareils radio exempts de li-
cence.
L'exploitation est autorisée
aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil doit ac-
cepter tout brouillage radioélectrique
subi, même si le brouillage est suscep-
tible d'en compromettre le fonction-
nement.
Changes or modifications not ex-
pressly approved by the party respon-
sible for compliance could void the
user's authority to operate the equip-
ment.
IC: 22868 - VDIBRHS01
FCC ID: 2AMJS - VDIBRHS01
RF exposure:
1. The equipment complies with FCC
RF exposure limits set forth for an
uncontrolled environment.
2. This equipment must be installed
and operated with a separation dis-
tance of at least 20 cm from all per-
sons.
3. The antenna(s) used for this trans-
mitter must not be co-located or
operating in conjunction with any
other antenna or transmitter.
Mexico
IFETEL
Marca: Robert Bosch LLC
Modelo(s): VIPHI2BT
Número: RCPBOVI18-0967
NOM-121-SCT1-2009
La operación de este equipo está su-
jeta a las siguientes dos condiciones:
(1) es posible que este equipo o dis-
positivo no cause interferencia perju-
dicial y (2) este equipo o dispositivo
debe aceptar cualquier interferencia,
incluyendo la que pueda causar su op-
eración no deseada.
150
______________