Can-Am SPYDER RS, Operator'S Manual

Page: 24 / 147

BASIC PROCEDURES
License Plate Installation
When a license plate needs to be in-
stalled or replaced, ensure to install
two new damping pads (P/N 293 740
028) on plate to be installed.
rmo2008-002-009
DAMPING PAD (P/N 293 740 028)
1. Remove existing plate on vehicle (if
applicable).
2. Position new damping pads over ex-
isting pads on vehicle plate support.
rmo2008-002-010_a
1. Existing pads on plate support
3. Peel off backing of new damping
pads.
rmo2008-002-009_a
1. Backing
4. Secure upper portion of license
plate using existing hardware on
vehicle plate support.
rmo2008-002-010_b
1. Existing hardware
5. Squeeze license plate and support
together at each lower corner.
Adjusting Mirrors
Press the mirror at the points shown
below to adjust its position in the four
directions.
rmo2008-001-081_a
MIRROR ADJUSTMENT POINTS
Locking the Handlebar
To lock the steering mechanism:
1. Insert key in ignition switch.
2. Rotate the handlebar all the way to
the right or to the left.
3. Turn the key 1/4 turn counterclock-
wise to the steering lock position
then remove key.
22
______________