SETUP
A
B
1
C
D
rmo2008-027-105_b
HEADLIGHT REFLECTION ON TEST SURFACE — HIGH BEAM
1. Focus point
A. 828 mm (32-19/32 in) above ground
B. 738 mm (29-1/16 in) above ground
C. 464 mm (18-9/32 in) above ground
D. 374 mm (14-23/32 in) above ground
Select low beam.
Beam aiming is correct when the focus point of
headlight reflection is between lower marks.
C
D
1
A
B
rmo2008-027-104_b
RH TRAFFIC HEADLIGHT REFLECTION ON TEST SURFACE —
LOW BEAM
1. Focus point
A. 828 mm (32-19/32 in) above ground
B. 738 mm (29-1/16 in) above ground
C. 464 mm (18-9/32 in) above ground
D. 374 mm (14-23/32 in) above ground
A
B
1
rbl2009-001-008_b
LH TRAFFIC HEADLIGHT REFLECTION ON TEST SURFACE —
LOW BEAM
1. Focus point
A. 464 mm (18-9/32 in) above ground
B. 374 mm (14-23/32 in) above ground
NOTE:
For LH traffic country application, low
beam headlights must have been replaced as
described in this predelivery bulletin.
High Beam
Turn adjustment screws to adjust beam height.
Adjust both headlights evenly.
rmr2008-027-102_a
ADJUSTMENT SCREWS
Low Beam
Insert a long Phillips screwdriver into air duct to
reach the adjustment screws.
rmr2008-027-106_a
1. Air duct
2. Screwdriver
Turn adjustment screws to adjust beam height.
Adjust both headlights evenly.
B.U.D.S. Programming
Always use the latest B.U.D.S. version on your
shop computer. It is available from the following
web site:
WWW.BOSSWEB.BRP.COM
NOTE:
At time of printing, the latest B.U.D.S. ver-
sion is 3.0.5.4.
NOTICE
During data transfer, make sure that:
– Voltage (12V) remains stable before starting
update. Charge the battery or use a power
pack to have enough power.
– Although screen ''freezes'' for a while, re-
main on the B.U.D.S. because update still
continues
– Never disconnect any cable while updating
ECM.
24 / 37
2012-1
PREDELIVERY
