Can-Am Rally 200, Operator'S Manual, Page: 87 / 140

SPECIAL PROCEDURES
Engine Overheat
If engine overheats and indicator light
turns on, try the following:
– Check and clean radiator fins. See
MAINTENANCE section.

WARNING
The radiator can be very hot, wear
gloves before touching radiator.
– Reduce vehicle speed but try to
keep vehicle moving to supply air
to radiator. If engine is still over-
heating after approximately one
minute, stop vehicle and set trans-
mission to NEUTRAL and apply
parking brake. Stop engine.
– Let engine cool down. Check
coolant level and refill if possible.

WARNING
In order to avoid potential burns,
do not remove the radiator cap or
refill cooling system when engine
is hot.
– Restart the engine, if the light does
not turn off right after engine start-
ing, stop engine and disconnect the
temperature sensor.
1
V06C2EY
2
1. Temperature sensor
2. Thermostat housing
Restart engine. If the light stays on, a
low oil pressure of the engine must be
considered. Stop engine immediately.
Otherwise, if the light turn off and the
engine is cold or warm, not hot, a po-
tential problem with the sensor or en-
gine part is possible. Use the vehicle
as little as possible and see an autho-
rized Can-Am dealer as soon as possi-
ble.
Turn Over
When vehicle is turned over or stays
tilted on the side, replace the vehi-
cle in its normal operating position (on
all four wheels) and wait 3 to 5 min-
utes before starting engine. Before
starting engine, check engine oil level
and refill if necessary. If the oil pres-
sure light stays ON after starting en-
gine, stop engine and see an autho-
rized Can-Am dealer as soon as pos-
sible.
_____________________
85