Can-Am Hero-BK-PM, User Manual, Page: 3 / 32

3
1.
Product Overview
1.1 Product Introduction
CAN-AM Access Control with AI thermal detector Hero-BK-PM adopts the new AI chip-set, large
thermal sensor array, and latest algorithm, providing the cutting-edge face recognition and body
temperature detection, with ability to detect wearing the mask. Hero-BK-PM can identify human
forehead automatically from 0.3meter ~1.2meter to get ±0.3
℃
high accuracy body temperature
within 0.05second.
1.2 Product Functions

Proximity wake-up activation: the device is automatically activated when a person
approaches.

7-inch touch screen: displays the software interface, operation guidance and face frame.
Performs real-time face detection (supports local video preview).

2 million pixel binocular wide angle camera.

Anti-fake function for pictures and videos.

Facial recognition distance of up to 1 meter, for a height range of 1.4m to 1.9m.

Use of deep learning algorithms to support a capacity of 50,000 faces. Fast recognition
with a higher recognition rate.

Storage of up to 50,000 events.

Multiple authentication methods.

Facial comparison time ≤ 0.5s/person. Recognition rate ≥99.9%.

Support for importing of card and facial data to devices through TCP/IP transmission or
USB interfaces.

Uploading of data through the internet.

Uploading of comparison results and interconnected snapshots to the platform for
storage.

Personnel information can be sent down from the platform or uploaded from local
devices.

Stand-alone operation in offline mode.

Local login for managing, searching and configuring device parameters.
2. Wiring instructions
Face recognition terminal can be docked through the tail line access control locking, in the
retention of existing access control system function of the colleague, the access control intelligent
operation upgrade. It is possible to simulate the opening of the door with the PUSHOUT signal and
directly drive the electromagnetic anode or cathode locks with the LOCKNONC signal.
For direct drive of Anodic or cathodic locks, a 12V/2A switched power supply is recommended.
Note the following while wiring.

If 1.0mm national standard wire is used, 12V switching power supply is used, and the wiring