CPB-515 Operation and Maintenance Manual
– TTS 45, 70, 80,100, 110 Series (10-2017)
18
3. Verify turnbuckle jamb nut torque. Tighten as required to 670 Nm +/- 65 Nm
5.7 Annual maintenance or every 500 working hours
1. Repack carrier roller wheel bearings (item 6) (if equipped).
Carrier Roller Spanner Nut Size
Torque (N-m)*
Torque (ft-lb)*
N-06
10 +/- 2
7.4 +/- 1.5
* Spanner nut tool 2P-0022 is available from your Camso dealer
5.8 Every 5 years or 2000 working hours
1. Drain and replace idler, midroller, and midroller pivot reservoirs.
2. Oil level should reach to lower level of fill plug with unit parked on level surface.
5.9 Off Season Storage
1. For optimum life, TTS tracks should be stored indoors, in dry environment with
a temperature between 5° and 25° C (40-77F). The tracks should not be
exposed to direct sunlight or heat. No petrochemicals and related vapors, no
electrical devices producing ozone should be placed in the same area.
2. Should it be necessary to disassemble the tracks from the undercarriage, lay
them on the ground on one edge avoiding bending radius less than 30 in.(750
mm). Do not lay the rubber components on dirty surfaces contaminated by oil,
grease or other chemical products
