IP Telephone User Guide
62
11
Troubleshooting
This chapter provides information to help you to diagnose any problems
you may be having with your Flexor 500 device.
Resetting to factory defaults
It is possible to restore your Flexor 500 back to its factory default state.
This action can potentially erase all your settings and address
book entries, so you should choose to keep all the settings
and the address book entries that you want to save when
asked to do so.
To reset your Flexor 500 to its factory default state, follow the procedure
below:
Select the Flexor 500 option from the main management web page.
Select Reset Settings in the top of the window.
The following window is displayed:
To reset the device to its factory default state, click on Reset and
Restart.
If you would like to keep some of the settings you have configured for
the device, click on the check box alongside the setting that you want
to preserve and then click on Reset and Restart.
The web browser window is closed and the device is reset.
If you can't access the web pages, it is also possible to reset
the device using the menu system. See Reset to defaults on
page 42 for full details.
If there are further problems then it is possible to delete all of the settings
by restarting the device while holding down the 0 button when the device
Note
Warning
