Campbell Wind Monitor Series, Product Manual

Page: 11 / 30

Table 7-1: Wire color, wire function, and data logger connection
Wire color Wire function Data logger connection terminal
Red WS signal
U configured for pulse input
1
, P (pulse input),
or P_LL (pulse, low-level AC)
Black WS signal reference ⏚
Green WD signal
U configured for single-ended analog input
1
,
SE (single-ended, analog input)
Blue WD voltage excitation
U configured for voltage excitation
1
, EX,
VX (voltage excitation)
White WD signal reference ⏚ (analog ground)
Clear Shield ⏚ (analog ground)
1
U terminals are automatically configured by the measurement instruction.
7.2 Programming
Short Cut is the best source for up-to-date data logger programming code. If your data
acquisition requirements are simple and you are connecting the sensor to a pulse terminal, you
can probably create and maintain a data logger program exclusively by using
Short Cut . If your
data acquisition needs are more complex, the files that Short Cut creates are a great source for
programming code to start a new program or add to an existing custom program.
NOTE:
Short Cut cannot edit programs after they are imported and edited in CRBasic Editor .
A Short Cut tutorial is available in QuickStart (p. 2). If you wish to import Short Cut code into
CRBasic Editor to create or add to a customized program, follow the procedure in Importing
Short Cut code into CRBasic Editor (p. 17). Programming basics for CRBasic data loggers are
provided in the following sections. Complete program examples for select CRBasic data loggers
can be found in
Example programs (p. 18). Programming basics and programming examples for
Edlog data loggers are provided at www.campbellsci.com\old-manuals .
7.2.1 Wind speed
Wind speed is measured by using the PulseCount() instruction. Syntax of the the
PulseCount()
instruction is:
PulseCount (Dest, Reps, PChan, PConfig, POption, Mult, Offset)
Wind Monitor Series 9