Appendix C. Terminal Commands
C-5
DUMP – Show Measurement Parameters:
Usage:
DUMP\r\n
Response:
\r\nSetup has been configured as follows:
\r\n
Vp = [vp value]
\r\n
Ave = [number of averages value]
\r\n
Points = [number of points value]
\r\n
Distance (Cable Length) = [cable length value]
\r\n
Window Length = [window length value]
\r\n
Probe Length = [probe length value]
\r\n
Probe Offset = [probe offset value]
\r\n
Probe Cell Constant = [probe cell constant value]
\r\n
50/60 Hz Rejection = [rejection Hz value]
\r\n
Filter Level = [filter level value]
\r\n Length Apparent Algorithm = [LAA value]
Each line containing a value has an appropriate number of space
characters to ensure that 26 total characters are between the ‘\n’
character and the ‘=’ character.
GLCO – Return previously calculated Electrical Conductivity value
Usage:
GLCO\r\n
Response: \r\n[f.ffff] – where f.ffff is an ASCII representation of a floating
point value (4 decimal places)
GCO – Acquire a new Waveform and return Electrical Conductivity value
Usage:
GCO\r\n
Response: \r\n[f.ffff] – where f.ffff is an ASCII representation of a floating
point value (4 decimal places)
GDE – Get the Derivative of the last Waveform acquired
Usage:
GDE\r\n
Response: \r\n[NNNN],[space][f.ffff]
\r\n[NNNN],[space][f.ffff]
\r\n[NNNN],[space][f.ffff]
etc.
where NNNN is the 4 digit width point number and f.ffff is an ASCII
representation of the associated floating point value (4 decimal places)
GDRV – Acquire a new Waveform and return its Derivative
Usage:
GDRV\r\n
Response: \r\n[NNNN],[space][f.ffff]
\r\n[NNNN],[space][f.ffff]
\r\n[NNNN],[space][f.ffff]
etc.
where NNNN is the 4 digit width point number and f.ffff is an ASCII
representation of the associated floating point value (4 decimal places)
GLMO – Get water Content value from the last Waveform acquired
Usage:
GLMO\r\n
Response: \r\n[f.ffff] – where f.ffff is an ASCII representation of a floating
point value (4 decimal places)
NOTE