Campbell SkyVUE 8, Product Manual

Page: 66 / 116

Description of the least significant alarm word (right side, bits going left to right)
Bit Description
XXXX XXXX 8000 Photo diode temperature is out of range
XXXX XXXX 4000 Photo diode is saturated
XXXX XXXX 2000 Photo diode calibrator temperature is out of range
XXXX XXXX 1000 Photo diode calibrator has failed
XXXX XXXX 0800 The sensor could not reach the desired gain levels
XXXX XXXX 0400 Laser run time has been exceeded
XXXX XXXX 0200 Laser temperature out of range
XXXX XXXX 0100 Laser thermistor failure
XXXX XXXX 0080 Laser is obscured. This can only be set if the laser is on
XXXX XXXX 0040 Laser did not achieve significant output power
XXXX XXXX 0020 Laser max power exceeded
XXXX XXXX 0010 Laser max drive current exceeded
XXXX XXXX 0008 Laser power monitor temperature out of range
XXXX XXXX 0004 Laser power monitor test fail
XXXX XXXX 0002 Laser shutdown by top board
XXXX XXXX 0001 Laser is off
5.1.8 Message polling
The
POLL Sensor_ID Message_ID
command requests the
Message_ID
from the
Sensor_ID . Where Message_ID is a SkyVUE 8 message type as defined in MCFG command
message types (p. 42).
The following example uses the SkyVUE 8
POLL
command to request preconfigured message
outputs.
First configure the SkyVUE 8 to use polling mode from the terminal interface via the
MCFG
command as follows:
CS136>
MCFG 0
0 1 0 0 0 0
SkyVUE™8 (CS136) LIDAR Ceilometer 54