Campbell Sierra Wireless RavenXTV, Instruction Manual

Page: 18 / 50

RavenXTV CDMA Sierra Wireless Cellular Modem
10
2. Plug the RavenXTV into power.
3. While the LED lights cycle from the outside to the inside, the RavenXTV
is attempting to download its account information. The download process
may take one to two minutes to complete.
Do not move your RavenXTV while it is being programmed.
4. When the Network light is on solid, your RavenXTV has successfully
completed OTASP and is registered on the Verizon network.
4.6 Indicator Lights
When your RavenXTV is connected to power and an antenna, there is a
specific pattern to the lights to indicate its operation mode.
• Network —On solid indicates a successful connection to the cellular
network with an IP address given and a channel acquired. Flashing
indicates that the modem is attempting to authenticate on the network.
• Signal —Light shows the strength of the signal and may be nearly solid
(strong signal) or flashing (weaker signal). A slow flash indicates a very
weak signal.
•
Activity
—Lights will flash as data is transferred to and from the PinPoint
modem on the remote network.
•
Power —Indicates the power adapter is connected and there is power
getting to the RavenXTV.
• The Reset button (on the left side of the RavenXTV) has two functions. If
it is quickly depressed and released, the modem will simply power cycle
the internal hardware. If, however, the reset is depressed and held for
several seconds (count to 10 slowly and wait for the power light to go off
after the light pattern stops), the ALEOS configuration settings will return
to the factory defaults.
4.6.1 Light Patterns
The LEDs on the front of the modem will respond in different patterns to
indicate modem states.
•
Normal
—Each LED, mentioned above, lit as applicable.
CAUTION