6. Select the Repeaters Used box.
7. Apply to save your changes.
B.2.2 Configuring the data logger acting as a repeater
1. Supply power to the data logger. If connecting via USB for the first time, you must first
install USB drivers by using
Device Configuration Utility
(select your data logger, then on
the main page, click Install USB Driver). Alternately, you can install the USB drivers using EZ
Setup. A USB connection supplies 5 V power (as well as a communications link), which is
adequate for setup, but a 12 V battery will be needed for field deployment. Ensure the data
logger antenna is connected.
2. Using
Device Configuration Utility
, connect to the RF451/RF452 data logger.
3. Click the RF451/RF452 sub-tab and select the Repeaters Used box.
RF451/RF452 Spread Spectrum Radio
33
