Campbell PVS5120 Series, Instruction Manual

Page: 82 / 102

Appendix C. Monitoring Sampler Status via RS-485
C-4
FIGURE C-4. Device Configuration VSC100
3. Once connected to the VSC100, you are ready to configure your sampler.
4. Click the Sampler Settings tab.
a. Set the PakBus® address or the Modbus® Address
i. The default PakBus® address for the sampler is 95. This value
needs to be unique for each sampler and datalogger on your
network.
ii. The default Modbus® address is 1. The value can range from 1
to 127. Each sampler on your network will need a unique
address.
5. You do not need to change any of your time-based or pulse control
settings.
6. Click Apply . It is a good idea to save the configuration file for
troubleshooting.