OBS-3+ and OBS300 Suspended Solids and Turbidity Monitors
4. Quickstart
4.1 Preparation for Use
1.
Bench test the sensor to ensure that it functions properly prior to making
field installations (see Section 7.1,
Pre-Deployment Tests
).
2.
Calibrate the sensor using suspended solids from the waters that will be
monitored (see Section 8,
Calibration
)
.
3.
Refer to Section 7.2,
Mounting Considerations
, for siting and mounting
options.
4.2 Use SCWin to Program Datalogger and Generate Wiring
Diagram
Short Cut
is an easy way to program your datalogger to measure the sensor and
assign datalogger wiring terminals. The following procedure shows using
Short Cut
to program the OBS-3+/OBS300.
1.
Install
Short Cut
by clicking on the install file icon. Get the install file
, the ResourceDVD, or find it in
installations of
LoggerNet
,
PC200W
,
PC400
, or
RTDAQ
software.
2.
The
Short Cut
installation should place a Short Cut icon on the desktop of
your computer. To open
Short Cut
, click on this icon.
2
Summary of Contents for OBS-3+
