Campbell Company
906-0003 AGPS Installation Manual Rev D.docx
Advisor Guide Pedestrian Signal
[Version D]
Document Name: Installation Manual
© Company 2014. All rights reserved.
Page 8 of 15
2.6
Installation Procedure
Base Station Installation
Tactile Arrow Orientation
Mount the Base Station so the tactile arrow is pointing directly to the crossing destination. Some
installations do not call out arrow directions and require installation in the field. The tactile arrow
is field selectable (left or right) requiring two security screws and a security driver. Campbell
Company provides this hardware packet only when specified at the time of purchase. Contact
Campbell Company Technical Support if a security bit is needed for tactile arrow modification.
Note: THE PEDESTRIAN RELIES ON THIS INFORMATION TO CROSS SAFELY.
Rubber mounting bumpers screw on to the back plate of the Base Station. These are adjustable
allowing for a number of configurations to ensure a precision fit - especially on decorative, small
diameter poles where the station needs to be angled to provide accurate directionality at the
arrow.
Drill and Tap Pole
1. Refer to Template 1 for diagram
2. Center the Base Station on the pole with the push
button
at the appropriate height (36 – 42” inches center).
3. Mark the point where the PPB will be centered.
4. Mark for a hole 1 1/8” above PPB center, and
drill a 1 1/8” hole
5. Mark for a hole 2 1/4” “above PPB center -
drill and tap for a ¼-20 thread
6. Mark for a hole 10 3/8 “above PPB center -
drill and tap for a ¼-20 thread
Template 1
