Campbell GPS16X-HVS, Product Manual

Page: 5 / 29

GPS16X-HVS GPS Receiver
2
1.2 Compatible Data Loggers
Compatible Contemporary Data Loggers
CR300
Series
CR800
Series CR6 Series CR1000X CR1000 CR3000 CR9000X


*
 

*

*

**
*If PPS is required, the A300 Power and Signal Converter is needed.
**CPU Card RS-232 port only.
This manual provides information only for CRBasic data loggers.
For retired Edlog data logger support, see an older manual at
www.campbellsci.com/old-manuals .
Except for the CR9000(X), our data loggers use the CRBasic GPS() instruction
to read the GPS16X-HVS. To use the PPS functionality, some data loggers
need an updated clock chip. The clock chip is factory replaced (refer to
Assistance page for more information). Data loggers with the following serial
numbers need an updated chip:
Data Logger Serial Number
CR1000M < 20409
CR800 Series < 7920
CR3000 < 3168
In August 2014, Garmin changed the PPS output signal from 5 V to 3 V. Units
with serial numbers greater than 1A4189318 have a 3 V PPS output signal.
Because of this, the CR800-series, CR1000, and CR3000 data loggers need the
A300 power and signal converter to use the PPS signal output. The A300 is
NOT required for the CR6-series, CR1000X, or CR300-series data loggers.
1.3 Common Accessories
The following common accessories are described at
www.campbellsci.com/gps16x-hvs
:
• GPS16X-HVS Magnetic Mount
• CM235 Magnetic Mounting Stand
•
A200 Sensor to PC Interface
• A300 Power and Signal Converter
• DB9 Female to Terminal Block with Hood and Hardware Kit
2. Precautions
•
READ AND UNDERSTAND the
Safety
section at the front of this
manual.
• When wiring the GPS16X-HVS, connect Ground before connecting 12V.
NOTE