Campbell GPS16X-HVS, Product Manual

Page: 11 / 29

GPS16X-HVS GPS Receiver
8
TABLE 6-2. CR9000X Wiring
GPS16X-HVS CR9000X Function
Red
12 V (SDM or 9011
connector)
Power In
Black
Ground (SDM or 9011
connector)*
Power Ground
Yellow
Ground (SDM or 9011
connector)*
Power Switch
White
RS-232 pin 3 (using
28841)
TXD
Gray
RS-232 pin 9 (using
28841)
PPS
Blue No Connection N/A
Shield
Ground (SDM or 9011
connector)*
Shield
*All of the grounds to the RS-232 pin 5 (using the DB9-Male-to-Terminal Block
interface). A 5-position terminal connector can be used to facilitate connecting all of the
wires into the same terminal.
6.1.1 Using with an A300
In 2014, Garmin changed the pulse-per-second (PPS) output of the
GPS16X-HVS from 5 V to 3 V. Units with a serial number 1A4189318 or
greater have a PPS output of 0 to 3 V. For those units, an A300 is needed to
connect the PPS output to a CR800-series, CR3000, or CR1000 data logger.
Those data loggers require the PPS line to have a voltage of 3.8 V or greater.
TABLE 6-3. GPS16X-HVS Wiring to A300 Terminals
and Data Logger Terminals
GPS16X-HVS
Wire Color
GPS16X-HVS
Wire Function
A300
Terminal Data Logger
Red 12 V
12V
Black Ground G
Yellow Enable
G
or
C
terminal
White TXD (Output)
C
(even) (Rx)
Gray PPS 3.3V IN
Blue Ground Ground
Shield Shield Ground