Campbell CS300, Product Manual, Page: 11 / 26

1
CS300 and CS301 Pyranometers
1. Introduction
The CS300 and CS301 measure total sun and sky solar radiation for solar,
agricultural, meteorological, and hydrological applications. Their spectral
range of 360 to 1120 nanometers encompasses most of the shortwave radiation
that reaches the Earth surface. These pyranometers connect directly to our
dataloggers. Their output can be measured by all of our dataloggers.
The CS301 replaced the CS300 in August 2018. The CS301 has a stainless
steel connector, a removable cable, different wire colours, and a serial number
of 60051 or above. Both sensors are manufactured by Apogee Instruments.
This manual provides information only for CRBasic dataloggers.
For retired Edlog datalogger support, you can access a retired
manual at
www.campbellsci.com/old-manuals .
2. Precautions

READ AND UNDERSTAND the Safety section at the front of this
manual.

Carefully open the shipping package ensuring to not damage or cut the
cable jacket. If the cable is damaged, consult with Campbell Scientific.

Remove the green cap after installing the sensor. Save this cap for
shipping or storing the sensor.

Handle the sensor carefully when cleaning. Be careful not to scratch the
surface of the sensor.

The black outer jacket of the cable is Santoprene® rubber. This compound
was chosen for its resistance to temperature extremes, moisture, and UV
degradation. However, this jacket will support combustion in air. It is rated
as slow burning when tested according to U.L. 94 H.B. and will pass
FMVSS302. Local fire codes may preclude its use inside buildings.
3. Initial Inspection

Upon receipt of the pyranometer, inspect the packaging and contents for
damage. File damage claims with the shipping company.
4. QuickStart
A video that describes datalogger programming using Short Cut is available at:
www.campbellsci.eu/videos/cr1000x-datalogger-getting-started-program-part-
3
. Short Cut is an easy way to program the datalogger to measure the
pyranometer and assign datalogger wiring terminals. Short Cut is available as a
download on www.campbellsci. eu . It is included in installations of LoggerNet ,
PC200W , PC400 , or RTDAQ .
NOTE