Campbell CR800 Series, Operator'S Manual, Page: 112 / 598

Section 7. Installation
112
Public PTemp, batt_volt
DataTable (Test,1,-1)
DataInterval (0,15,Sec,10)
Minimum (1,batt_volt,FP2,0,False)
Sample (1,PTemp,FP2)
EndTable
BeginProg
Scan (1,Sec,0,0)
PanelTemp (PTemp,250)
Battery (Batt_volt)
CallTable Test
NextScan
Include "CPU:IncludeFile.CR1" '<<<<<<<<<<<<<<<'include' file code executed here
EndProg
'Include' File to Control SW12 Terminal.
'This program example demonstrates the use of an 'include' file. See the documentation in
CRBasic example
'Using an Include File
(p. 111)
'
'<<<<<<<<<<<<<<<<<<<<<<<NOTE: No BeginProg instruction
SlowSequence '<<<<<<<<<<NOTE: Begins with SlowSequence
Scan (1,Sec,0,0)
If TimeIntoInterval (9,24,Hr) Then SW12 (1) 'Modem on at 9:00 AM (900 hours)
If TimeIntoInterval (17,24,Hr) Then SW12 (0) 'Modem off at 5:00 PM (1700 hours)
NextScan
'
'<<<<<<<<<<<<<<<<<<<<<<<NOTE: No EndProg instruction
7.5.1.5.3 Executable File Run Priorities
1. When the CR800 powers up, it executes commands in the powerup.ini file (on
Campbell Scientific mass storage device including commands to set the
CRBasic program file attributes to Run Now or Run On Power-up .
2. When the CR800 powers up, a program file marked as Run On Power-up
will be the current program.
3. If there is a file specified in the Include File Name setting, it is compiled at
the end of the program selected in step.
4. If there is no file selected in step 1, or if the selected file cannot be compiled,
the CR800 will attempt to run the program listed in the
Include File Name
setting. The CR800 allows a SlowSequence statement to take the place of
the BeginProg statement. This allows the "Include File" to act as the default
program.
5. If the program listed in the Include File Name setting cannot be run or if no
program is specified, the CR800 will attempt to run the program named
default.cr8 on its CPU: drive.