10.4.41 PakBusPort
This setting specifies the TCP service port for PakBus communications with the data logger.
Unless firewall issues exist, this setting probably does not need to be changed from its default
value. Default 6785.
10.4.42 PakBusTCPClients
This setting specifies outgoing PakBus/TCP connections that the data logger should maintain.
Up to four addresses can be specified.
l
String data type
10.4.43 PakBusTCPEnabled
By default, PakBus TCP communications are enabled. To disable PakBus TCP communications,
set the PakBusPort setting to 65535.
10.4.44 PakBusTCPPassword
This setting specifies a password that, if not empty, will make the data logger authenticate any
incoming or outgoing PakBus/TCP connection. This type of authentication is similar to that used
by CRAM-MD5.
l
String data type
10.4.45 PingEnabled
Set to one to enable the ICMP ping service.
10.4.46 PCAP
PCAP is a packet capture (PCAP) file of network packet data (network traffic) that can be opened
by Wireshark. This setting specifies the network interface, file name, and maximum size of the
PCAP file. For example:
l
"usr:debug.pcap" saves the file to the USR drive with the file type .pcap.
l
".ring." found in name will create new files once the file size has been reached.
"crd:debug.ring.pcap" creates crd:debug001.pcap, crd:debug002.pcap...
l
If a number follows .ring. then only that number of files will be saved, with the oldest
deleted. For example: "usr:debug.ring.3.pcap" will save three files.
If All Networks is selected as the Network Interface and PPP/Cell is active, then separate files will
be opened for the PPP/Cell network with "ppp." prefixed on the file name.
10. Information tables and settings (advanced)
183
