Campbell CR300 series, Operator'S Manual, Page: 28 / 86

CR300-Series Datalogger
18
4.7 View Data
Open View Pro .
LoggerNet
:
From the LoggerNet toolbar, click
Data | View Pro .
Click File | Open to open a file for viewing. In the dialog box, select the data file to view. A data file has a .dat
extension. Click Open .
The collected data are now shown.
Learn more about the fields
displayed in Section 5.7 , Collecting
Data
(p. 23)
.
NOTE Check out the View Data Tutorial to learn more.
4.8 Install the CR300
The CR300 and most of its peripherals must be protected from moisture.
Moisture in the electronics will seriously damage the CR300. In most cases,
protection from water is easily accomplished by placing the CR300 in a
weathertight enclosure with desiccant and elevating the enclosure above the
ground. Desiccant in enclosures should be changed periodically.
Do not completely seal the enclosure if lead-acid batteries are
present; hydrogen gas generated by the batteries may build up to
an explosive concentration.
FIGURE 4-2 shows a typical installation using a Campbell Scientific
enclosure. The CR300 has mounting holes through which small screws are
inserted into nylon anchors in the backplate.
NOTE
View data in the OneMin table by opening the CR300Series_OneMin.dat file in the C:\Campbellsci\LoggerNet
folder.
Data Table Header
Data Records