Campbell CR300 series, Operator'S Manual, Page: 19 / 86

CR300-Series Datalogger
9
In the
Table Monitor
, select a data
table in the Table Monitor list. The
table is now displayed. Each table
will update as described in Section
5.6 , Monitoring Data
(p. 23)
.
Click
Disconnect
to end the session.
4.3 Create a Program
Short Cut is an easy way to program your CR300 datalogger to measure
sensors. Short Cut is included in installations of LoggerNet . It is also available
as a download on
www.campbellsci.com
and the
ResourceDVD
.
This section will guide you through programming a CR300-Series datalogger
to measure the voltage of the CR300 power supply, the internal temperature of
the CR300, and the ambient air temperature using a thermocouple. With minor
changes, these steps can apply to other measurements.
Watch the video for Sections 4.3 – 4.4:
CR300 QuickStart Part 3
.
Open
Short Cut
.
LoggerNet :
From the
LoggerNet
toolbar, click
Program | Short Cut .
Select
New Program
.
View the Public table by selecting the Public table in the Table Monitor list.