Campbell CR23X, Operator'S Manual

Page: 75 / 374

SECTION 5. TELECOMMUNICATIONS
5-3
TABLE 5.1-1. Telecommunications Commands
Command Description
[F.S. Area] A SELECT AREA/STATUS - If 1 or 2 does not precede the A to select
the Final Storage Area, the CR23X will default to the Area last used
(initially this is Area 1). All subsequent commands other than A will
address the area selected. Datalogger returns
R eference, the DSP
location; the number of F illed Final Storage locations; V ersion of
datalogger; Final Storage A rea; L ocation of MPTR (the location
number may be 1 to 7 characters long); E rrors #1, #2, #3, and #4
where #1 is the number of E08's, #2 is the number of overrun errors,
#3 is the number of times the program stopped due to low voltage,
and #4 is the number of times the 5 V supply dropped below 5V (all
are cleared by entering 8888A; #2 is also cleared at time of program
compilation); size of total
M emory in CR23X in Kbytes; the lithium
B attery voltage; and C hecksum. All in the following format:
R+xxxxx. F+xxxxx. Vxx Axx L+xxxxxxx. Exx xx xx xx Mxxxx B+x.xxxx Cxxxx
If data is stored while in telecommunications, the A command must
be issued to update the Reference to the new DSP.
[no. of arrays] B BACK-UP - MPTR is backed-up the specified number of Output
Arrays (no number defaults to 1) and advanced to the nearest start
of array. CR23X sends the Area, MPTR Location, and Checksum:
Ax L+xxxxxxx Cxxxx
[YR:DAY:HR:MM:SS] C RESET/SEND TIME - If time is entered the time is reset. If only 2
colons are in the time string, HR:MM:SS is assumed; 3 colons
means DAY:HR:MM:SS. If only the C is entered, time is unaltered.
CR23X returns year, Julian day, hr:min:sec, and Checksum:
Yxx Dxxxx Txx:xx:xx Cxxxx
[no. of arrays] D ASCII DUMP - If necessary, the MPTR is advanced to the beginning
of the next array. CR23X sends the number of arrays specified (no
number defaults to 1) or the number of arrays between MPTR and
Reference, whichever is smaller, CRLF, FSA, Location, Checksum.
E End call. Datalogger sends CRLF only.
[no. of loc.] F BINARY DUMP - Used by CSI software for data retrieval. See
Appendix C.
[F.S. loc. no.] G MOVE MPTR - MPTR is moved to specified Final Storage location.
The location number must be entered. CR23X sends Area,
Location, and Checksum:
Ax L+xxxxxxx Cxxxx
7H or 2718H REMOTE KEYBOARD - CR23X sends the prompt ">" and is ready
to execute standard keyboard commands (Section OV3). Aborted
by pressing any key (except *, D , #) on local keypad.