Campbell CR10X, Instruction Manual, Page: 78 / 363

CR10X User Guide
3-12
Table 3-9 Error Codes
Code Type Description
03 Editor Program Table full
04 Compile Intermediate Storage full
05 Compile Storage Area 2 not allocated
08 Run Time CR10X reset by watchdog timer
09 Run Time Insufficient Input Storage
10 Run Time Low battery voltage
11 Editor Attempt to allocate more Input or Intermediate
Storage than is available
12 Compile Duplicate *4 ID
20 Compile SUBROUTINE encountered before END of
previous subroutine
21 Compile END without IF, LOOP or SUBROUTINE
22 Compile Missing END (P95)
23 Compile Non-existent SUBROUTINE
24 Compile ELSE in SUBROUTINE without IF
25 Compile ELSE without IF
26 Compile EXIT LOOP without LOOP
27 Compile IF CASE without BEGIN CASE
30 Compile IF and/or LOOP nested too deep
31 Run Time SUBROUTINES nested too deep
32 Compile Instruction 3 and interrupt subroutine use same
port
33 Compile Cannot use Control Port 6 as counter or interrupt
subroutine with Instruction 15 or SDM
40 Editor Instruction does not exist
41 Editor Incorrect execution interval
60 Compile Insufficient Input Storage
61 Compile Burst Measurement Scan Rate too short
62 Compile N<2 in FFT
68 Compile Instruction 118 without enough Instructions 68 or
63
92 Compile Instruction 92, intervals in seconds: Time into
Interval >59 or Interval >60
94 *D MODE Program Storage Area full
95 *D MODE Program does not exist in flash memory
96 *D MODE Addressed device not connected or wrong address
(see Table 1-8).
97 *D MODE Data not received within 30 seconds
98 *D MODE Uncorrectable errors detected
99 *D MODE Wrong file type or editor error