Campbell CPEC300, Product Manual, Page: 172 / 175

Appendix L. CPEC300 Series Pump Replacement
L-6
10. Cut the blue (inlet) and red (outlet) tubing on each side of the pump
behind the barbed connector as shown in FIGURE L-10 .
FIGURE L-10. Location of cuts to remove pump assembly from tubing
11. Remove the pump from the assembly.
L.3 Installation
To reinstall a CPEC300 pump, carry out the following steps:
1. Position the pump with the label up and connect the coiled tubing on
both sides of the pump (see FIGURE L-11 ). Blue tubing connects the
inlets and red connects the outlets as directional arrows show on the
side of the pump (FIGURE L-12 ).
FIGURE L-11. Inlet and outlet tubing reconnected to pump