Campbell AVW200 series, Instruction Manual

Page: 61 / 112

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules
' Example Program running SDI12 commands with the Datalogger controlling
' 2 mux's. For this program, the AVW SDI-12 port is connected to DL C1.
' The reset line of both muxes is connected to datalogger C3. Mux1 clock line
' is connected to DL C4 and Mux2clock line is connected to DL C5. The SDI-12
' address of the AVW200 is set to 1.
SequentialMode
Public PTemp, batt_volt
Public Chan1_Val(16,6),Chan2_Val(16,6)
Dim I
BeginProg
Scan
(150,Sec,0,0)
PanelTemp(PTemp,250)
Battery(Batt_volt)
PortSet(3, 1) ' Reset High, Mux On, both mux's share this reset port
Delay(1, 100, mSec) ' delay before clocking
' ************ Measure 16 vibrating wire sensor on AVW200 channel 1
For I=1 To 16
' Advance Mux #1 (clock line connected to C4; clock high for 2mSec)
PulsePort(4, 2000)
Delay(1, 10, mSec) ' Mux Settling Time
'measures sensor on channel 1
SDI12Recorder (Chan1_Val(I,1),1,1,"M1!",1.0,0)
Next I
' ************ Measure 16 vibrating wire sensor on AVW200 channel 2
For I=1 To 16
' Advance Mux #2 (clock line connected to C5; clock high for 2mSec)
PulsePort(5, 2000)
Delay(1, 10, mSec) ' Mux Settling Time
'measures sensor on channel 2
SDI12Recorder (Chan2_Val(I,1),1,1,"M2!",1.0,0)
Next I
PortSet(3, 0) ' Reset Low; turn both Muxes off
NextScan
EndProg
53