FT-405 Mari Fountain
Assembly Instructions
rev 7/11/22
Fountain Information:
• This fountain holds approximately 1/2 gallon of water.
• A fountain cover is not available for this fountain.
• No refill device or submersible lights are suggested for this fountain.
Pump Information:
WP450LV - 120 GPH Low Voltage Pump (16 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Scissors
Pump Kit Parts List
Image
Component
Quantity
PK120-LV pump with transformer
1
#7 Stopper
1
2-1/2" length of PermaGum Putty
1
Ball-Valve
1
Approx. 8" length of 1/2" black
non-kink tubing
1
1" length of 5/8" clear tubing
1
1" length of 1/2" CPVC pipe
1
Adhesive Dots
4
Hose Clamp
1
Fountain Components
Image
Item Description
Component
Item #
Quantity
Mari Fountain -
Water Feature
FT-405A
1
Mari Fountain -
Basin
FT-405B
1
Proudly
MADE IN USA
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
