ERGOPOWER WL CONTROLS - Rev. 03/ 08-2022
CAMPAGNOLO COMPONENTS - USER MANUAL
12
DRAFT
7 - MAINTENANCE/CLEANING/TRANSPORT/STORAGE
7.1 - FIRMWARE UPDATE PROCEDURE
Press the MODE button on the Ergopower control: the LED lights up pink and then BLUE; at this point release the button.
The LED lights up GREEN: quickly press the MODE button on the Ergopower control.
The rear derailleur will wait for an update for 2 minutes. The LED flashes green. Next, follow the instructions in the MyCampy app.
If you do not want to update the firmware, turn off the control.
!
The GREEN LED lights up only once. If you do not press the MODE button, the cycle ends without any change being made.
WARNING
7.2 - CLEANING
• The duration of the components is variable based on the conditions of use, frequency and quality of maintenance. To ensure the components are well
maintained, these must be cleaned frequently, especially in more extreme usage conditions (e.g. after every time the bicycle is washed, or ridden on wet,
dusty or muddy roads, etc.).
Take care to ensure that no lubricants, oils, solvents or waxes for polishing the frame are deposited on the brake pads or discs. If this
occurs, the braking power will be reduced or lost completely. In these circumstances, the bike must not be used. Do not attempt to
clean the pads, but instead simply replace these, and clean the discs with a degreasing agent. Failure to observe the above conditions
could result in accidents, physical injury or death.
WARNING!
• Make sure the pads are not embedded with any debris (stones, broken glass, etc.); if this is the case, remove this.
Do not use products to reduce the noise when braking - these products also reduce the braking power, and as such, can lead to
accidents, physical injury or even death.
WARNING!
• Use cleaning products that are compatible with braking systems which use mineral oil. Do not use cleaning products for systems which use DOT oil, as
these can damage the rubber seals irreparably.
• Never wash your bicycle using pressurised water. Pressurised water - even from a normal garden hose - may infiltrate the seals and get into your
Campagnolo®, components, causing irreparable damage to them. Wash your bicycle and the Campagnolo® components by delicately cleaning with water
and neutral soap.
IMPORTANT :
when cleaning the bicycle, only use environmentally-friendly and neutral products without caustic substances which are safe to use for you
and for the environment.
• Check that any holes present in the bottom bracket shell are not obstructed and let water drain from the frame.
Saline conditions (such as roads in winter and in coastal areas) may cause galvanic corrosion in the majority of the exposed bicycle
components. To prevent damage, malfunctions and the consequent risk of accident, carefully rinse, clean and dry all components that
are subject to corrosion.
WARNING!
• Cleaning and user maintenance shall not be made by children without supervision.
